Well that is him printed. I still need to design a levitation base to make him float above the table top but the actual model is complete.
I intend to add some Greenstuff lianas to the top where the disk joint is. You can just about see it on the photo above.
As you can see, he is quite tall. Because I removed the lumps and bumps and horns of the bottom he isn’t much taller than the original measurement yesterday. I reckon the base will be an inch high.
He took over 27 hours to print as he is. Add in the couple of error prints then we are up to 40 hours print time.
For those that were wondering what he is… voila….